Looking for:
Logic Pro X Cheat Sheet | ShortcutFoo. |
Zoom Super Fast in Logic Pro X – Professional Composers.
If a project has more tracks than are currently visible in the Tracks area, a vertical scroll bar appears along the right edge of the Tracks area. Drag the scroll bar up or down to see the other tracks. Drag the Horizontal Zoom slider left to zoom out for a wider view, or drag it right to zoom in for a close-up view.
Because sometimes you will mess up the zoom, and knowing that you can always use this command to go back to the previous zoom setting, in several steps, can be a blessing many times. If you hold down the command key while you drag the bottom of a track up or down, you will set the default track height on all tracks. This will also set all tracks to that zoom level in height, in case you had different track heights in your projects previously.
See Use the Event Float window. If more than one region is selected, all subsequent regions are moved. For audio regions, the region anchor is placed at the current playhead position. This command only works for timestamped audio files, such as those recorded in the current project, and imported Broadcast Wave or SDII files. Resize: When you resize the right edge of a region, the regions that follow move by the change in length.
For both Shuffle R and Shuffle L, when you drag one region over another, the regions switch positions. Only one audio region at a time can be played on each track.
When two audio regions on the same track overlap, only the later right region is heard. Set the drag mode for the Tracks area In Logic Pro, choose one of the following modes from the Drag pop-up menu in the Tracks area menu bar: Overlap: Preserves the current region borders when you drag one region over another. You can select and edit parts of one or more regions , using the Marquee tool or the marquee stripe:.
Marquee tool: Use to select and edit region parts by dragging across them. The Marquee tool looks like a crosshair. Marquee stripe: A thin stripe shown at the top of the ruler. Only the part of the region inside the marquee is selected, letting you select inside, or across portions of, regions. You can perform most edits, such as moving, cutting, copying, and deleting, in the selected area. After editing, the selected area becomes a new, separate region.
The marquee selection uses the current Tracks area Snap value. If you play a project after making a marquee selection, playback starts at the left edge of the selection, and ends at the right edge. If you create a marquee selection while the project is playing, playback continues past the end of the selection. If you start recording after making a marquee selection, Autopunch mode is activated, and the marquee selection is replaced by the punch locators.
All tracks within the marquee selection are record-enabled, and all other tracks are record-disabled. In Logic Pro, select the Marquee tool, then drag in the Tracks area to select parts of one or more regions. Drag in the thin marquee stripe area of the ruler to select parts of one or more regions also shown on selected tracks.
Press and hold Shift, then click in the Tracks area to change the selection in any direction. Press and hold Shift while using the Left Arrow key or Right Arrow key to move the marquee start point.
Pinch open to zoom in, or pinch closed to zoom out. When the pointer is over an empty part of the Tracks area , you can simply press and hold the Option key.
In Logic Pro, click the background with the Zoom tool. This action returns the zoom level to the original setting, or backtracks through previous zoom steps if the tool was used multiple times.
Zoom the Tracks area or editor using the playhead In Logic Pro, press and hold Option as you click and hold in the lower section of the ruler , then drag the top of the playhead up or down. Because sometimes you will mess up the zoom, and knowing that you can always use this command to go back to the previous zoom setting, in several steps, can be a blessing many times.
If you hold down the command key while you drag the bottom of a track up or down, you will set the default track height on all tracks. This will also set all tracks to that zoom level in height, in case you had different track heights in your projects previously.
No comments:
Post a Comment